* Atmel High Speed MultiMedia Card Interface

This controller on atmel products provides an interface for MMC, SD and SDIO
types of memory cards.

1) MCI node

Required properties:
- compatible: no blank "atmel,hsmci"
- reg: should contain HSMCI registers location and length
- interrupts: should contain HSMCI interrupt number
- #address-cells: should be one. The cell is the slot id.
- #size-cells: should be zero.
- at least one slot node

The node contains child nodes for each slot that the platform uses

Example MCI node:

mmc0: mmc@f0008000 {
	compatible = "atmel,hsmci";
	reg = <0xf0008000 0x600>;
	interrupts = <12 4>;
	#address-cells = <1>;
	#size-cells = <0>;

	[ child node definitions...]
};

2) slot nodes

Required properties:
- reg: should contain the slot id.
- bus-width: number of data lines connected to the controller

Optional properties:
- cd-gpios: specify GPIOs for card detection
- cd-inverted: invert the value of external card detect gpio line
- wp-gpios: specify GPIOs for write protection

Example slot node:

slot@0 {
	reg = <0>;
	bus-width = <4>;
	cd-gpios = <&pioD 15 0>
	cd-inverted;
};

Example full MCI node:
mmc0: mmc@f0008000 {
	compatible = "atmel,hsmci";
	reg = <0xf0008000 0x600>;
	interrupts = <12 4>;
	#address-cells = <1>;
	#size-cells = <0>;
	slot@0 {
		reg = <0>;
		bus-width = <4>;
		cd-gpios = <&pioD 15 0>
		cd-inverted;
	};
	slot@1 {
		reg = <1>;
		bus-width = <4>;
	};
};
